5 Feb 2026

Evaluating Snow Pavement Strength in Remote Cold Environments via California Bearing Ratio (CBR) and Russian Snow Penetrometer (RSP) Combined Testing

Abstract: Accurate assessment of compacted snow strength is critical for ensuring the safety and performance of snow runways in cold environments. The Russian Snow Penetrometer (RSP) is widely used in snow science and engineering due to its simplicity, portability, and capability for rapid field measurements under extreme conditions. Conversely, the California Bearing Ratio (CBR) test remains the benchmark for evaluating the load-bearing capacity of conventional granular materials but is seldom applied to snow because of logistical constraints and the material’s complex mechanical behavior. The relationship between these two pavement evaluation tools remains poorly defined. This work investigates how RSP strength indices relate to CBR measurements to determine whether the RSP can serve as a practical proxy for snow pavement load-bearing capacity. Side-by-side field measurements of snow pavement strength were collected over a 30 h period at two test section locations. Both methods captured temporal strength increases and spatial variability, with consistently higher values at the second site attributed to extended sintering. A moderate linear correlation (R2 = 0.44) between RSP and CBR results supports a quantifiable relationship between the two methods. These findings begin to bridge the gap between conventional pavement testing and snow-specific strength evaluation, demonstrating the potential of the RSP for rapid assessment of snow runways. Continued data collection and analysis will refine this relationship and strengthen its applicability for operational use.

7 Jul 2022

Validation of the Automatic Dynamic Cone Penetrometer

Abstract: The U.S. military requires a rapid means of measuring subsurface soil strength for construction and repair of expeditionary pavement surfaces. Traditionally, a dynamic cone penetrometer (DCP) has served this purpose, providing strength with depth profiles in natural and prepared pavement surfaces. To improve upon this device, the Engineer Research and Development Center (ERDC) validated a new battery-powered automatic dynamic cone penetrometer (A-DCP) apparatus that automates the driving process by using a motor-driven hammering cap placed on top of a traditional DCP rod. The device improves upon a traditional DCP by applying three to four blows per second while digitally recording depth, blow count, and California Bearing Ratio (CBR). An integrated Global Positioning Sensor (GPS) and Bluetooth® connection allow for real-time data capture and stationing. Similarities were illustrated between the DCP and the A-DCP by generation of a new A-DCP calibration curve. This curve relates penetration rate to field CBR that nearly follows the DCP calibration with the exception of a slight offset. Field testing of the A-DCP showed less variability and more consistent strength measurement with depth at a speed five times greater than that of the DCP with minimal physical exertion by the operator.